Liqui Moly Liquifast 1402 (BAG SET) 400ml - 6155

1-component, cold-application and moisture-curing adhesive as direct-glazing sealant for vehicle windows in the case of repairs. Includes the “Liquiclean” cleaner and the “Active Primer” glass and paint primer. Liquifast 1402 was tested in crash tests by TÜV and is characterized by its fast hardening properties and excellent rigidity. Vehicles whose windows were bonded using Liquifast 1402 are ready to be driven again after just 1.5 hours (with or without driver airbag) or 3 hours (with front passenger airbag) of drying time according to general test conditions.

AREAS OF APPLICATION

• For bonding front, rear and side windows into the bodywork of motor vehicles (cars, trucks, drivers’ cabins of tractors/forklifts and special vehicles) as well as for bonding side windows made from a single pane and insulation glass in bus and train car construction

APPLICATION

• 1
• Cleaner
  The surfaces to be bonded must be dry, free from oil, dust, grease and other dirt residues
• The glass surface or ceramic coating is cleaned with Liquiclean or Cleaner and Thinner (part no. 6130) and then with Windshield Cleaner Foam (part no. 1512), as are the bodywork flange or newly painted body components
• We recommend also cleaning the remaining adhesive beading that has been trimmed back with Liquiclean or Cleaner and Thinner
• Before applying the sealant or bonding the window, the cleaned bonding surface must be completely dry
• 
  
  2
• Priming/activation of pre-coated windows
  Active Primer is required for adhesive pre-treating during window bonding
• The Active Primer is included in the set as a 10 ml stick
• Shake Active Primer well for at least 45 seconds before use
• Active Primer can be applied universally in the bonding area thinly and evenly (approx
• 0
• 05 mm wet-film thickness) on the cleaned glass surface or ceramic screen printing, on the clean paint surface of newly painted car-body components, on remaining adhesive beadings that have been trimmed back and pre-coated windows (PUR and RIM coatings)
• The primed surface must be allowed to air off for about 15 min
• before applying the windshield adhesive
• 
  If the remaining adhesive beading was trimmed back more than 6 hours ago, pre-treatment with Active Primer is mandatory
• 
  

ADDITIONAL INFORMATION

• Adhesive/sealing compound for direct glazing
• The adhesive must be used in conjunction with the corresponding glass cleaner and the corresponding primers
• To be processed when cold
• Drive-away times for standard climate: Without/with driver’s airbag: 1
• 5 hours; double airbags: 3 hours
• Processing time: 10 min

PROPERTIES

• Cold working
• Proven oem quality
• Tüv tested
• Single-component
• Fast bonding properties
• Cured by moisture in the air
• High viscosity

TECHNICAL DATA